What lengths do LED strip lights come in?
An LED strip light is typically half an inch (10-12 mm) in width, and up to 16 feet (5 meters) or more in length. They can be cut to specific lengths using just a pair of scissors along the cutlines, located every 1-2 inches.
What is the maximum length of LED strip?
LED strips are typically manufactured in 5m reels, as this is roughly the maximum length you can install in one continuous length without getting a voltage drop towards the end of the reel. Any longer, and the LEDs at the end of the reel appear less bright than those close to the power supply.
Can LED strip lights be extended?
Solder-Free LED Wire Connector: Your project might require your LED light strips to go around a corner or an unusual shape. … These wire connectors have clips on both ends so you can use them to connect two LED light strips with each other. They are great for extending the length of your LED light strips.
Can LED strip lights stay on all night?
Can you leave them on overnight? Yes, LED lights are ideal for leaving on for long periods of time due to their low power usage and very low heat output. They are more suited to use as a night light/ background accent light in general.
Can LED strip lights catch fire?
The LEDs will not give off enough heat to catch on fire or burn your bed, ever. This project could easily be the fusion of 2 well engineered products to do something cool without any risks!
Are LED Strip Lights bad for your eyes?
The AMA says that life-long exposure of the retina and lens to blue peaks from LEDs can increase the risk of cataract and age-related macular degeneration. Studies also reveal that light emitted by LEDs can cause retinal changes, if there is high exposure for even a short period of time.
Where should LED strips be placed in a room?
Once your coving is in place, a good tip for positioning your LED tape is to fix it as far from the back wall as you can, so as to avoid seeing visible light-dotting. (Try to fit your coving so the LEDs will sit at least 100mm down from the ceiling, and at least 50mm from the wall.)
Do LED strips use a lot of electricity?
LED strip lights do not cost a lot of electricity compared to traditional incandescent lights. … It’s been shown that the electricity used over the lifetime of a single incandescent bulb costs 5-10 times the original purchase price of the bulb.
Can you connect LED strip lights together?
You can easily connect two LED strip lights together, considering they come in reels with marked dotted lines for cutting the strips into the size needed. These strips can then be joined in two ways: Using connectors or soldering the strips’ copper pads.
How do you connect LED strip lights to mains?
How do I install my LED strip lighting? To get your strip light working, connect the transformer / driver to the strip light ( extending the cable with 2 core flex if necessary). Then you connect your transformer / driver to the mains via a plug or direct to the mains and you’re away.
Can you connect 3 LED light strips together?
Vetco recommends, as a general rule, not to connect more than three complete strips end-to-end without adding in extra, higher gauge power wire or additional power supply units down the line.
Can LED strip lights be left on 24 7?
To put it simply, well-manufactured LED lights are extremely long-lasting and can be left on 24 hours, 7 days a week. This is because, unlike conventional types of light, LEDs produce minimal amounts of heat, which means they are unlikely to overheat or set on fire.
Do LED strips take off paint?
Paint is not invincible, it ages and becomes more fragile over time. So paint that has been on the wall for several years is more likely to peel off with your LED strips. … Your paint job will be much weaker and more susceptible to damage from LED strip lights.
Why do my LED strip lights glow in the dark?
It’s somewhat-likely that your strip LED lights are picking up a tiny current from adjacent cabling (or just possibly, via the light switch; if you have a remote or similar, there may be a snubber across relay contacts, which passes a milliamp or so). In general, it’s completely safe that your lights still glow.