How do I reset my monster LED light?

Insert a paper clip, or a similar sized object, into the reset hole on the controller (depicted below). Using the paper clip, press and hold the reset button inside the reset hole for eight (8) seconds. If done successfully, the light strip will flash five times then cycle through the colors blue, green and red.

How do I get my monster LED light to work?

1: Press and hold the pairing button on the device and ensure that the LED indicator is now blinking RAPIDLY. 2: Open the Monster Smart app. From the add device list, click on “Lighting (WiFi)”. 3: Follow the on-screen instructions to confirm that the LED indicator is rapidly blinking.

How do you reset LED lights without remote?

These are the typical steps to do that:

Hold the power button for five seconds then turn off the power. Wait for 3 seconds then turn it on for five seconds. Repeat the 3 seconds off and five-second on the process for 4 times. On the fourth time, wait for the LED strips to show alternate lights.

IT IS INTERESTING:  Do LED bulbs attract bugs?

How do I fix my LED light not working?

Check for any visible loose connections, make sure all of your connectors and wires are in place and have not fallen out. Try tightening screws on DC adapters, and re-inserting LED strips into solderless connectors, which are common contact failure points.

Why are my monster LED lights flashing?

When you overload your power supply by drawing too much wattage from the output, your LED strip lights will begin to flash in a consistent pattern. … To avoid this, always check the total wattage that the power supply can handle and make sure the total wattage of the LED strips is less than that number.

Are Monster LED lights good?

5.0 out of 5 stars These are really good lights. … These lights were easy to put up and work really well.

Is there an app for Monster LED lights?

‎Monster Smart App on the App Store.

Why is my remote for my LED lights not working?

If your remote control suddenly stops working or your lights start blinking, you may need to reset the controller and pair it back to the receiver unit. The controller sometimes un-pairs itself from the receiver due to a loose connection, radio interference from an external source or a low battery in your remote.

Why won’t my LED lights change color?

Bad Pin Connection – If your LED strip light fails to turn on at all, then check your pin connections. … If your RGB strip lights won’t change colors try flipping your strip light around and reconnecting it. Incorrect Power Source – Make sure to double check which power source your lights require.

IT IS INTERESTING:  What chemicals are used in LED lights?

Can I use a different remote for my LED lights?

Yes,One remote can control multiple receriver, you need to match code with receiver firstly,following the steps: plug in the LED strips light with the receiver and power supply, using remote, holding the “ON” 5 seconds, then LED strips light would flash,it means the remote has paired with the receiver successfully, rep …

How do I open my LED remote?

To open up the compartment where the battery is, you’ll want to squeeze the little black tab on the back bottom left of the remote in towards the larger black tab next to it. Squeeze the little tab in and pull the compartment out with your finger or nail, and it should slide out.

Why are half of my LED lights a different color?

Color shifts are experienced at the end of the LED strips.

Typically, if the end of the LED strip is of a different brightness or color than the beginning of the strip, there is insufficient power being provided to the device.

Lighting blog