How do I reset my monster LED strip light?

Why are my LED strip lights not working?

Bad Pin Connection – If your LED strip light fails to turn on at all, then check your pin connections. Most likely, the pin is not inserted correctly. In rare cases, the pin is faulty. … If your RGB strip lights won’t change colors try flipping your strip light around and reconnecting it.

What does DIY mean on LED light remote?

Using the “DIY” buttons on the controller you can create custom colors. When you press one of the six DIY buttons, the color will change to white, from there, use the color coded arrows on the controller to change the color to whatever you like!

Do LED strip lights burn out?

Unlike incandescent bulbs which burn out and fluorescent lamps which begin to flicker, LEDs behave differently in that over time, they slowly and gradually lose their light output.

How do I reset my DIY LED light color?

Step 1, Make sure all part of the LED strips kit are connects right and powered. Step 3, Press the “FADE7” button ,it will flash one second. Step 4, Turn on the LED strips again, press Red, Green, blue button one by one, it will change to its original color.

IT IS INTERESTING:  Are LED lights good for fish tank plants?

How do you make LED lights work again?

How To Reset LED Strips

  1. Plug your LED strips in and turn it on for a few seconds.
  2. Turn it off then take out the power adaptor without turning off the remote control.
  3. Press and hold the power button for a few seconds then connect the power supply again.

Why can’t I make DIY colors on my LED lights?

If your LED strips are stuck on one color when you change colors, it’s probably because you have been pressing the same color button, which reaches peak value. Try using the reverse button to adjust it higher or lower. If still to no avail, check the contact of your pins and reconnect.

Why are my LED lights 2 different colors?

If two primary color within the group of three LED elements are missing, this simply means that two surface-mounted components (resistors) have been damaged. Observe the PCB strip around the location of the missing primary color (red, green, or blue) and see if you see any damage.

Can you use a different remote for LED lights?

Yes,One remote can control multiple receriver, you need to match code with receiver firstly,following the steps: plug in the LED strips light with the receiver and power supply, using remote, holding the “ON” 5 seconds, then LED strips light would flash,it means the remote has paired with the receiver successfully, rep …

How do I connect LED lights to my phone?

How to Use Smart LED Strip Lights with EZ Mode

  1. Step 1: Download LampUX App. Android and iOS users can go to the App store and download LampUX App on your phone, then register an account.
  2. Step 2: Set Up the Smart LED Light Strip. Turn on the LED strip lights and wait for 10 seconds. …
  3. Step 3: Connect the App.
IT IS INTERESTING:  Do LED lights need a plug?

17 июл. 2020 г.

How do you pair a monster LED bulb to a remote?

To pair LED strips or LED light bulbs to another remote, simply unplug and replug back in the LED strip or lamp to power and WITHIN FIVE SECONDS of plugging back into power, press and hold the “Speed+” until the lights blink three times.

Lighting blog