Question: Why are only half of my LED lights working?

Yes, LED christmas light strands are often two independent circuits. The LEDs are connected in series, so if one is disconnected or somehow failed open circuit, that circuit will go out. Of course the same will happen if there is a break somewhere in the wire.

Why are half of my LED strip lights not working?

Bad Pin Connection – If your LED strip light fails to turn on at all, then check your pin connections. Most likely, the pin is not inserted correctly. In rare cases, the pin is faulty. … If your RGB strip lights won’t change colors try flipping your strip light around and reconnecting it.

Why does only half a string of lights work?

If half a strand is working and the other half is not, you probably have a loose or broken bulb. … If not, you have the more tedious job of going down the row of unlit bulbs, one at a time, and swapping them for a known, good bulb until you find the culprit. You’ll know it when the strand lights back up.

How can I reset my LED lights?

Step 1, Make sure all part of the LED strips kit are connects right and powered. Step 3, Press the “FADE7” button ,it will flash one second. Step 4, Turn on the LED strips again, press Red, Green, blue button one by one, it will change to its original color.

IT IS INTERESTING:  Can I use LED bulbs in halogen fittings?

Why wont my LED lights turn red?

Most likely it is a poor connection on the Red wire, A standard DVM meter will test LEDS like these, just set to Ohms and place the leads across a red LED and see if it lights up. If that doesn’t do it, reverse lead polarity.

How long do LED Strip Lights last?

LEDs have an unbelievably long expected life-span, compared to both incandescent and fluorescent lights. With an average life-expectancy of some 50,000 hours, LED strip lights will still be burning bright in 17 years’ time, long after their traditional counterparts will have expired.

Will Light Keeper Pro work on LED lights?

The LightKeeper Pro’s Quick Fix Trigger will only work in series Miniature Light sets with shunted bulbs. The LightKeeper Pro would not be appropriate for the larger lamped C7, C9 sets, tube/rope lights or LED Lights. … The control box will block the pulse before it reaches the defective bulbs.

How do I fix fairy lights not working?

How to Fix a String of Christmas Lights

  1. Diagnose the problem. Carefully inspect each string of lights before plugging it into an electrical outlet. …
  2. Find the bad bulb, and swap it out. …
  3. Fix the faulty filament or shunt. …
  4. Replace the fried fuse. …
  5. Upgrade your lights.

19 нояб. 2020 г.

Why are my LED lights 2 different colors?

If two primary color within the group of three LED elements are missing, this simply means that two surface-mounted components (resistors) have been damaged. Observe the PCB strip around the location of the missing primary color (red, green, or blue) and see if you see any damage.

IT IS INTERESTING:  Can you reconnect cut LED strips?

Why is my LED controller not working?

If your remote control suddenly stops working or your lights start blinking, you may need to reset the controller and pair it back to the receiver unit. The controller sometimes un-pairs itself from the receiver due to a loose connection, radio interference from an external source or a low battery in your remote.

Lighting blog