Why is one of my LED light strips not working?

Bad Pin Connection – If your LED strip light fails to turn on at all, then check your pin connections. Most likely, the pin is not inserted correctly. In rare cases, the pin is faulty. … If your RGB strip lights won’t change colors try flipping your strip light around and reconnecting it.

How do I reset my LED strip light?

These are the typical steps to do that:

  1. Plug your LED strips in and turn it on for a few seconds.
  2. Turn it off then take out the power adaptor without turning off the remote control.
  3. Hold the power button for five seconds then turn off the power.
  4. Wait for 3 seconds then turn it on for five seconds.

What do you do if your LED strip lights don’t work?

To troubleshoot, try the following steps:

  1. 1) Confirm that your power supply’s voltage and current rating are compatible with your LED strip. …
  2. 2) Confirm that your power supply is working correctly. …
  3. 3) Check and isolate other accessories on the same circuit. …
  4. 4) Check for any visible loose connections.
IT IS INTERESTING:  Your question: Are Costco Feit LED string lights dimmable?

Why is one part of my LED lights a different color?

As established above, when LED strip lights don’t get enough cooling, they get overheated, and the diodes can change color.

How do I put batteries in my LED remote?

To open up the compartment where the battery is, you’ll want to squeeze the little black tab on the back bottom left of the remote in towards the larger black tab next to it. Squeeze the little tab in and pull the compartment out with your finger or nail, and it should slide out.

How long do LED Strip Lights last?

LEDs have an unbelievably long expected life-span, compared to both incandescent and fluorescent lights. With an average life-expectancy of some 50,000 hours, LED strip lights will still be burning bright in 17 years’ time, long after their traditional counterparts will have expired.

Why are my LED lights two different colors?

If two primary color within the group of three LED elements are missing, this simply means that two surface-mounted components (resistors) have been damaged. Observe the PCB strip around the location of the missing primary color (red, green, or blue) and see if you see any damage.

Can you connect LED Strip Lights after cutting?

Yes, LED strip lights will carry on working after they’ve been cut as long as you cut along the designated lines. LED strips are made up of several individual circuits, so each cut line demarcates the end of one circuit and the start of a new one.

IT IS INTERESTING:  Can you dim LED string lights?

Can I cut LED light strips?

LED Strip Lights can be cut at 5 or 10 cm intervals, depending on the type of strip light purchased. The “cutting points” are clearly marked with a straight line. To seperate your strip lights, cut along the line using a pair of scissors or craft knife.

Why won’t my LED lights change color?

Bad Pin Connection – If your LED strip light fails to turn on at all, then check your pin connections. … If your RGB strip lights won’t change colors try flipping your strip light around and reconnecting it. Incorrect Power Source – Make sure to double check which power source your lights require.

How do you fix LED color?

Step 1, Make sure all part of the LED strips kit are connects right and powered. Step 3, Press the “FADE7” button ,it will flash one second. Step 4, Turn on the LED strips again, press Red, Green, blue button one by one, it will change to its original color.

Lighting blog