Why wont my monster LED lights work?

How do I get my monster LED light to work?

1: Press and hold the pairing button on the device and ensure that the LED indicator is now blinking RAPIDLY. 2: Open the Monster Smart app. From the add device list, click on “Lighting (WiFi)”. 3: Follow the on-screen instructions to confirm that the LED indicator is rapidly blinking.

How do I reset my monster LED strip light?

Here’s how to do it:

  1. Plug your LED strips in and turn it on for a few seconds.
  2. Turn it off then take out the power adaptor without turning off the remote control.
  3. Press and hold the power button for a few seconds then connect the power supply again.

Why is my LED light not working?

Bad Pin Connection – If your LED strip light fails to turn on at all, then check your pin connections. Most likely, the pin is not inserted correctly. In rare cases, the pin is faulty. … If your RGB strip lights won’t change colors try flipping your strip light around and reconnecting it.

IT IS INTERESTING:  Can I connect LED lights together?

What to do if your LED lights are not working?

Troubleshooting an LED Light Strip

  1. Check the Wires. Temporarily turn off the power source. …
  2. Check the Bulbs. If one or more of the bulbs has dimmed or gone out, check the manufacturer’s documentation for the type of circuit that was used to put the LED light strip itself together. …
  3. Check the Converter.

29 окт. 2010 г.

Why are my monster LED lights flashing?

When you overload your power supply by drawing too much wattage from the output, your LED strip lights will begin to flash in a consistent pattern. … To avoid this, always check the total wattage that the power supply can handle and make sure the total wattage of the LED strips is less than that number.

Are Monster LED lights good?

5.0 out of 5 stars These are really good lights. … These lights were easy to put up and work really well.

Why are my LED lights 2 different colors?

If two primary color within the group of three LED elements are missing, this simply means that two surface-mounted components (resistors) have been damaged. Observe the PCB strip around the location of the missing primary color (red, green, or blue) and see if you see any damage.

How do I reset my DIY LED light color?

Step 1, Make sure all part of the LED strips kit are connects right and powered. Step 3, Press the “FADE7” button ,it will flash one second. Step 4, Turn on the LED strips again, press Red, Green, blue button one by one, it will change to its original color.

IT IS INTERESTING:  What bulbs are better HID or LED?

Why wont my LED lights turn red?

Most likely it is a poor connection on the Red wire, A standard DVM meter will test LEDS like these, just set to Ohms and place the leads across a red LED and see if it lights up. If that doesn’t do it, reverse lead polarity.

Is it OK to leave LED lights on?

Can you leave them on overnight? Yes, LED lights are ideal for leaving on for long periods of time due to their low power usage and very low heat output. They are more suited to use as a night light/ background accent light in general.

Lighting blog