Although LED Christmas lights consume less energy and are generally safe for use, they still deal with electricity, so shortening your LED Christmas lights is still a risk. Make sure to follow all the steps and remember to be careful.
Can you cut LED string lights?
Rope light spools can be cut using either sharp scissors or a knife. … This is the only place that LED or incandescent rope light should be cut. The distance between the cut marks will vary depending on the rope light so it’s important to measure your space and choose the cut mark closest to that measurement.
Can you cut the end of string lights?
Only Cut Light Strings Designed to be Cut
Not all string lights are designed to be cut or shortened. Outdoor light strings with male and female end plugs are meant to be connected end to end. Shortening these lights voids the safety rating and can cause the string to no longer work.
Do LED lights attract bugs?
Bulbs that emit more short wavelengths of light (cool white/bluish color) will attract more bugs. … LED lights produce little to no UV light and a minuscule amount heat, which makes them less attractive to bugs—so long as they emit longer wavelengths of light.
Do LED lights still work when you cut them?
Due to their design, LED Strip Lights will continue to work even after they have been cut. This is because their circuit is completely closed at each cutting point. If you are removing a section from the end of your strip light, always make sure you are cutting it at the end away from the connector.
Can you trim LED fairy lights?
Yes you can if they are battery or USB-powered lights. Fairly lights are wired in parallel, not in series. Cut to the length you need, then join and insulate the end. The voltage doesn’t change since they are in parallel and amperage (minimal anyway since LED) is based off the draw of the components, not a push.
Are outdoor string lights safe?
Incandescent bulbs are safe for outdoor use as long as they are protected from direct contact with water. … Damp location rated bulbs can be used where moisture is present, but should not come in direct contact with water. LED bulbs with this rating should not be used for permanently installed light strings.
Can string lights get wet?
Outdoor string lights can get wet. … The IP rating tells you how well protected your outdoor lights are against dirt and moisture. You also need to ensure that the extension cords are rated for exterior use.
How do you cut patio string lights?
The lights are designed so each bulb receives all 120 volts and each bulb has a direct route to power, meaning they can be cut to any length without overpowering and burning out bulbs. With the lights unplugged cut wires with wire cutters between the bulbs and cap each end with wire connectors.
What can I do with extra string lights?
46 Awesome String-Light DIYs For Any Occasion
- Wrap them around an interestingly shaped mirror. …
- Wrap a strand of paper lantern string lights around a twig and hang above the bed. …
- Drape bigger bulbs casually to create an effortless lamp. …
- Drape lights over a bookshelf. …
- Create a tree. …
- Use them with clothespins to hang photographs.
14 дек. 2012 г.
What is the third wire on Christmas lights?
Some strings use a third-wire to allow 120V power to bypass sections of lights, this allows a single portion to go dark without affecting the other portion of the string. If there is a plug on the end, this is also where the full 120V comes from to power additional strings.